APEC 2020, March 18, 13:45-14:15h

Exhibitor Seminar: "9 Key Failures in Power Inductives"

Speakers: Antonio Rojas

Location: 211-213


We would like to invite you to join us at APEC conference! This year we will be part at the Magnetic Session with "the Graphene Based Power Magnetics: a New Material for Improved Performance Conference" and at the Exhibitor Seminar talking about "9 Key Failures in Power Inductives", to be held on Wenesday March 18st, 2020 (13:45-14:15h). Location: 211-213.
                 

9 Key Failures Power Inductives Session Abstract:  

            

A fatal failure in Power Electronics often ends up with the car stopped and having to be towed for service (best case) and expensive replacement of the full electrical system while a catastrophic failure could see the car burst into flames1 with very serious damage to the Car Makers’ reputation and a very serious situation for the car owner (worst case). Most of the issues that affect Lithium batteries in EV (pressure, heating, short circuits and flame risks are common with Power Electronics circuits and thus the same solutions apply). Causes of Failures that cause overheating (Breakdown & Fire):

  • Magnetostriction
  • Curie temperature
  • Core breaks and cracks
  • Short Circuits
  • Magnetic Saturation
  • Fire and ames
  • Fringing Fluxes & Gaps
  • Hot Spots and Short Circuited windings
  • Air cavities
  • Leaked Flux

Findings:

- An efficient cooling system in a 3.3KW device can save up to 34ºC of temperature

- PCM (Phase Change Materials) absorb a much higher amount of heat thanks to enthalpy.

- Customized thermal solution beat in performance and cost the market standards.

                   

Speaker

 Antonio Rojas

CTO & ECOSYSTEM, PREMO MALAGA

Antonio Rojas, engineer degree in electrical & electronic engineering, by Málaga Technical Engineering School), has more than 35 years of experience in several disciplines of Electronic Technologies.

He works in Fujitsu Limited (Málaga, before SECOINSA) during 10 years being responsible of Modems design, prototype and reliability testing (Environmental, EMC and safety), then he move to CETECOM (test house for electronics systems, CE-Marking, EMC lab, etc..) now is Dekra, being since 2005 President of CISPR SC-210 (CTN208, radio-electric disturbances) and finally was joined to Premo in 2007 to work in RFID systems, Product & Marketing responsible for RFID business, (getting a Master by EADA over Product Management), CTO and now with additional Managing of Ecosystem, supporting mainly Technology demand for the R&D process and Ecosytems formed by key suppliers, customer, Universities, prescribers, national and international forums relative to our core business.

                                                                                                               

Spotlight innovations at PREMO Stand:  

            

Stand: 1556

PREMO Highlights

3dpower,   Wireless charging Antenna,  Magnetics Power Electronics

Event Registration:

-Register here for your  visitor ticket

Location:

Ernest N. Memorial Convention Center;

New Orleans, LA. USA

https://apec-conf.org/