KGEA-DHS Door Handle Emitter Antenna LF for Automotive (+SWITCH) (0.285mH)

L (mH) MinDCR (Ω) MaxFreq. (kHz)Cres (pF)Q x,y,z MinHeight (mm)Width (mm)Length (mm)SRF (kHz) MinSensitivity (mV/uT) min
114.57.21570.3
Showing 1 - 1 of 1 item
Characteristics

Door Handle Emitter Antenna LF for Automotive (+SWITCH)

PREMO is developing customized door handle antennas using a type of technology over-molding low pressure depending on the
mechanical requirements and waterproof IP degree required by the customer.
For Door Handle Antennas, we also have the ability to integrate in a unique connector (6ways), the Antenna LF + Switch + LED as a
single whole.


Characteristics:

  • Overmolded Antenna with Low Pressure Technology (LPM)
  • LPM is a well know technology PREMO
  • Very fast to produce (No Curing needed)
  • Low Profile. Height max= 7,2 mm.
  • IP56 grade Waterproof.
  • Connector located outside assembly Antenna LF+ SWITCH
  • High stability in temperature (-40ºC up to +85ºC).
  • Resonant frequency adjusting below +/- 2kHz.
  • Custom L-C value @ F-Res
  • This antenna is designed based on AECQ-200 

Nomenclature description and Schematic Diagram

  •  L+C in series: 

KGEA-DHS nomenclature

Field Magnetic Strength:

Procedure/Setup

  • Antenna PREMO mounted on Reader and signal amplifier ( I=2App, V=5Vpp).
  • Probe FMZB 1538143 (as receiver) used to measure the magnetic field (dBμV/m).

 Result

  • 105 dBμV/m ± 2dB@3 meters (I=2App; V=5Vpp) in maximum direction.

Operating Frequency @114,5Khz @25ºC @1Vac. (L+C in series)

L (mH)Cres (nF)Q(L+C)Rac (Ω)ArmsFreq. (kHz)Length (mm)Height (mm)Width (mm)
KGEA-DHS-C-0285J 0.285 6.8

>135

<2 1A 114.5 70.3 70.2 15

Antenna is measured in resonant mode.

Dimensions

ELECTRICAL DIAGRAM

KGEA-DHS electrical diagram

Others

KGEA-DHS parts