ニュース
14/12/2011
SMD isotropic antenna for NFC applications (13.56MHz).
Premo launches to the market a new 3D-coil isotropic magnetic antenna for NFC applications (13.56MHz).
In the last few years, Communication technology by Near Field Communications (NFC) has experienced a lot of improvements. New tablets, smart phones, etc, has been announced with this NFC functionality for E-Wallet application.
The antenna has a high surface resistance NiZn ferrite core material......17/11/2011
Three Phase Filter (no neutral line) for Renewable Energy (Wind Generation)
Renewable energies are now becoming an ever-growing alternative to generating electricity. This is the case of power generation through windmills. The power injection on the network must be done cleanly; this means that the power generating must inject it with RF noise free. The radio frequency noise that typically range from 10kHz to 30MHz is unintentionally injected into the network and therefore requires the use of an appropriate filter element: this is both the......14/11/2011
New Hall Effect Current Sensor Designer Kit
PREMO launches a new Hall Effect sensors designer´s kit which integrates a set of different sensors from 6-300A. Development engineers can use the wide range of PREMO sensors in different applications.
The kit includes 19 functional samples of current sensors, open and closed loop, ready to use:
HCT-A05 Series: Closed Loop 1:1000. 25-35A. Series included in the HCT DK KIT: HCT-25A05 y HCT-35A05
HCT-AP Series:......18/10/2011
PREMO announces the retirement of its Hall Effect current transducer HCT-BS1 family and unveils mechanical changes in the HCT-BS family.
PREMO announces the retirement of its Hall Effect current transducer HCT-BS1 family and unveils mechanical changes in the HCT-BS family.
Family HCT-BS:
The only difference that can be appreciated in the brand new HCT-BS family lay in the output connector and gain control potentiometer positions.
Figure 1. Old HCT-BS:
Figure 2. New HCT-BS
Besides these mechanical changes, HCT-BS family electrical and......30/09/2011
PREMO unveils Hall Effect sensors with Primary integrated
Premo introduces a new series of Hall Effect sensors called the SY series. The new product has been designed for a double supply voltage of ±12 to ±18Vdc.
SY family is a closed loop technology component in a very small package for THT mounting. Primary winding is already integrated, which allows to measure DC, AC and pulse currents on printed circuit boards.
Key characteristic of this series......15/09/2011
RFID SMT Antenna with comprehensive protection for automotive applications
PREMO launches a new family of its 1103 standard, universally adopted by industry. This format provides up to 55mV/Apk-pk/m sensitivity which gives it the best sensitivity by cm3 in the market. The new SDTR1103CAP, is a SMD antenna for low frequency 20kHz-150kHz receiver applications. This series offers upper and lateral side protection with co-polyamide polyhexamethylene polymer walls, gamma radiated with high thermal stability......09/09/2011
PREMO Current Transducers HCT´s families receive UL Certification
Premo (Wuxi location) in China — a leading global provider of Inductive Components, today announced that its HCT-xxDS5, HCT-xxDSR5,HCT-xxPT5, HCT-xxPTR5, HCT-xxA05 y HCT-xxSY, devices received UL component certification.
These devices are open type, current transducer that senses an alternating and a direct current in a feed-through wire set up at the through-hole, by a Hall Effect principle through the closed loop......28/07/2011
Three phase EMC Filters for UPS up to 150A
IT systems are increasing every day, electronic devices that support them are more complex but also more reliable and they are able of working with adversities as failures in the power grid, either due to lack of supply or because quality of electric power is not good enough. Faced with these adversities, UPS is the best solution, providing stable power with high quality, although autonomy is limited.
Current UPS store energy in batteries in DC mode. When......18/07/2011
PREMO unveils Hall Effect sensors with Input reference pin
In the will of continuous customer support, Premo has introduced a new series ofHall Effect sensors called HCT-DSR5 series. A new series designed for a single supply voltage of +5V.
HCT-DSR5 family is a close loop technology component in a very small package for THT mounting. Primary winding is already integrated, which allows to measure DC, AC and pulse currents on printed circuit boards.
Key characteristic of this series is that includes......20/06/2011
PREMO GROUP announces a new distribution agreement in France with EQUIPEMENTS-SCIENTIFIQUE
The new distribution agreement is part of the growth process and international implementation that guides the Spanish inductive components manufacturer from the last 10 years. Present in France since 2008, with the opening of a R+D center in Grenoble, the group hopes to achieve through this partnership a leading position in the French market for passive components.
The long experience in the sector, its implementation and the quality of their equipment, make the French......02/06/2011
New HCT-DHR420 Hall Effect series with 4-20mA output
The continuous shortage on Hall Effect sensors in the market is generating big troubles on the industrial field and, of course, also in PV and eolic inverters manufacturers.
In order to continue supporting our customer, Premo has successfully introduced a complete new family of Hall Effect sensor, HCT-DHR420 Series, which is equivalent to LEM DHR-C420 family.
The main characteristic of this series is the output current, which is fixed in the range of 4 to 20mA. Such......27/05/2011
Premo designs for Linear Technology PFC Chipset application High Efficiency PFC Choke.
Linear Technology R&D center in California has just developed a new 3.3kW high efficiency and low size automotive battery charger using Premo PFC-001 choke. According to R&D engineer Tage Bjorklund “The results are surprisingly good. Compared with other inductors, the Premo inductor will reduce the power loss with 5.7W, both at 120Vac and at 220Vac input, at 63kHz switching frequency.”
Did you realize that an electric car is a net......19/05/2011
PREMO推出应用于直梯及扶梯上的新型EMC滤波器
为了获得更舒适的乘坐感受，目前电梯系统的运行于可变的速度，会有加速与制动。通过安装用AC变频器控制的曳引机得以实现。但是该种AC变频器工作于开关模式，从而产生许多的电磁干扰。这些所产生的电磁干扰必须通过EMC滤波器的抑制来保证干扰的峰值低于标准的限制值。
普莱默的EMC......10/05/2011
Fluxgate Current Transducers for Battery Monitoring Systems in Electric Vehicles
1. Battery Monitoring System (BMS) for electric vehicles.
Battery management system (BMS) of a electric vehicle (EV) in the different architectures needs a set of reliable set of sensors for current, voltage and temperature measurement to achieve a good control and monitoring. Those sensors are mounted in the battery pack to monitor different parameters like cell voltage, current through the cells, temperature of cells......
普莱默正在推广125khz,470uH（Q=90）的小发射天线(当然也适用于134.2khz, Q=95)
这种产品易使用于自动装片（对于小批量甚至可以手动生产）。
产品型号为X-D830-003，适合中短距离唤醒要求（约1米，取决于接收芯片），适合取代小型空心线圈（直径3-6厘米）
用于这种发射天线中的电容，常规为125......11/04/2011
Passive Keyless Entry Systems (PKE) is being incorporated into the most of mid-range vehicle
Whether a fuel, diesel, hybrid or electric vehicle, you need to open and close, secure and comfortable.
RKE (remote keyless entry) are available in the market since 1983 in two basic types of form factor: key separate from small remote control and integrated in to the car-key itself (most common today).
PKE technology is considered an evolution of RKE. For the most of vehicle brands, PKE systems are well known and in use for the......01/04/2011
PREMO provides LF antennas for Austria Microsystems AS3933 wake-up receiver.
AustriaMicrosystems announced the best-in-class 3-channel low-frequency wake-up receiver with 15 – 150 kHz range with automatic antenna tuning capability, theAS3933 Series. This receiver enables battery powered systems to add remote wakeup capability. In addition, with best-in-class sensitivity of 80μVrms, both range and BOM cost can be optimized while the lowest current consumption of 2.7μA extends battery life.
PREMO, RFID......31/03/2011
Energy Harvesters for Sensors, VEPGs devices
1. - Introduction.
In the latest years the use of devices implemented with sensors for the measurement of different parameters has extended ( temperature, humidity, acceleration, pressure, parameters…), these devices use in addition a radio frequency system to communicate that parameter to a central unit that manages it at monitorización level, alarms, activation of third elements, etc… many times these devices are......11/03/2011
EMC Filters for PV inverters up to 1500Amps.
PREMO launches a new EMC filter for PV installations, FEDC series, which allows EMC standards compliancy for entire PV system, prevent pre-mature panel aging and reduce installation volume.
Installed between the PV inverter and the solar panel, DC filters helps to meet EMC directives in grip-connected installations. FEDC Series have been designed to reduce conducted emissions towards the solar panel, to reduce EMI radiations from......01/03/2011
SMD antennas for HF/NFC applications (2 - 13,56 MH
In the last few years, Communication technology by Near Field Communications (NFC) has experienced a lot of improvements. New Iphone5 has been announced with this NFC functionality for E-Wallet application.
PREMO enlarges its SDTR1103 family with the new SDTR1103-HF series. This new SMD antenna is suitable for signal´s reception at 2MHz and/or 13,56MHz Tx/Rx for NFCapplications.
The antenna has a high......09/02/2011
How HEV technology is shaping Tier 2 automotive suppliers
Hybrid and Electric vehicles, by design, introduce many new electronic components into the bill of materials and account for up to 30% of the vehicles total cost. Years ago, Toyota was the only manufacturer with a hybrid car in mass production, but Toyota’s policy of integrating the supply chain into their own structure and utilizing only local factories made it impossible to develop sub-suppliers specializing in these new components. In 2011, all......03/02/2011
New Hall Effect current sensor up to 1000 Amps for Renewable Energies
The continuous shortage on Hall Effect sensors in the market is generating big troubles on the industrial field and, of course, also in PV and eolic inverters manufacturers.
In order to continue supporting our customers, Premo has successfully introduced a close loop 1000 Amps Hall Effect sensor mechanical and electrically equivalent to LEM LF-1005-S.
The new catalogue reference is HCT-1000LF.
Advantages and Key Characteristics:
......
...21/01/2011
PREMO & Wireless Technology through “Witech” radio module
Massive use of wireless devices in the 2.4 GHz band is producing what has been called the "ISM Revolution". ISM mean: Industrial, Scientific and Medical. ISM bands are frequency bands of free use (portions of the radio-electric spectrum, for which no license is required). It doesn´t mean that the devices operating on ISM bands are exempt from the regulations governing the use of those bands, both from the standpoint of radio (power, channel, duty cycle......17/01/2011
Premo Group launches a new DCF and ripple control antenna. A through-hole antenna for applications using atomic watch signals. The new RCA-THT Series.
There are several clock signal transmitters in different countries such as: DCF77-77.5kHz (Germany), HBG-75kHz (Switzerland), MSF-60kHz (United Kingdom), JJY-40&60kHz (Japan), WWVB-60kHz (USA), DCF49 (Germany): 129,1kHz (Mainfligen transmitter, 100kW), y 139kHz (Burg transmitter, 50kW), 135,6kHz (Laikhegy......